Elasto-plastic Analysis of High-strength Concrete Shear Wall with Boundary Columns Using Fiber Model

Source:
By:long Tong, Chen Fumin, Ou Yangjing, Xiao Sixi, Wu Jianliang

DOI: https://doi.org/10.30564/jcr.v2i1.2694

Abstract:

In this study, an experimental study and numerical calculations using fiber model were conducted for four high-strength concrete shear walls with boundary columns under low cyclic load. The boundary column and shear wall were divided into fiber elements, and PERFORM-3D finite element analysis software was used to carry out push-over analysis on the test specimens. The results show that the finite element analysis results were in good agreement with the experimental results. The proposed analysis method could perform elasto-plastic analysis on the high-strength concrete shear wall with boundary columns without distinguishing the categories of frame column and shear wall. The seismic performance of high-strength concrete shear wall with boundary columns was analyzed using the following parameters: axis compression ratio, height to width ratio, ratio of vertical reinforcement, and ratio of longitudinal reinforcement in the boundary column. The results show that the increase in the axial compression ratio causes the bearing capacity of the shear wall to increase at first and then to decrease and causes the ductility to decrease. The increase in the height to width ratio causes the bearing capacity of the shear wall to decrease and its ductility to increase. The ratio of vertical reinforcement was found to have little effect on the bearing capacity and ductility. The increase in the ratio of longitudinal reinforcement in boundary column resulted in a significant increase in the bearing capacity and caused the ductility to decrease at first and then to slowly increase.

References:

[1]LIANG Xingwen, YANG Penghui, CUI Xiaoling, DENG Mingke, ZHANG Xinghu. Experimental studies on seismic behavior of high strength concrete shear wall with boundary columns[J]. Journal of Building Structures, 2010,31(1):23-32. [2] HE Fanglong, ZHU Yapeng. A 3d model in nonlinear analysis of reinforced concrete shear wall with side column[J]. Engineering Mechanics, 2008,25(6):124-129. [3]Graham H Powell. A state of the art educational event performance based design using nonlineal analysis[R]. Computers and Structures, Inc.,2007. [4]Computers and Structures, Inc. Nonlinear anaysis and performance assessment for 3D structures user guide[M]. Berkeley, California, USA: Computers and Structures, Inc.,2006 [5]FEMA 356. Prestandard and commentary for the seismic rehabilitation of buildings[S]. Federal Emergency Management Agency:Washington,DC,2000. [6]Mander J B, Priestley M J N, Park R. Theoretical stress-strain model for confined concrete[J].Journal of structural engineering,1988,114(8):1804-1826. [7]GB 50010-2010 Code for design of concrete structures[S].Beijing: China Communication Press, 2011:63-64. [8] Qin BaoLin. Preliminary Evaluation on the Seismic Behavior of Super High-rise Structure Examples on the Support of PERFORM 3D Software[D].Chongqing: Chongqing University,2012. [9] TONG Xiaolong , FANG Zhi , LUO Xiao. Experimental study on seismic behavior of Reactive Powder Concrete shear walls[J]. Journal of Building Structures,2016,37(1):21-30. [10] Xiaowei Cheng, Xiaodong Ji, Richard S. Henry, Mengchao Xu. Coupled Axial Tension-Flexure Behavior of Slender Reinforced Concrete Walls[J]. Engineering Structures,2019,188:261-276.