Modeling Tensile Strength of Concrete on Partial Replacement of Cement and Sand with Quarry Dust Ground Granulated Blast Furnace and Slag Silica Fumes

Source:
By:Eluozo S.N., Dimkpa K

DOI: https://doi.org/10.30564/jbms.v3i1.2949

Abstract:

Tensile strength of concrete were examined on its partial replacement of cement and sand using ground granulated blast furnace and quarry dust, the study examines its behaviour at different dimensions, this is to monitor the variation effect of these parameters on the growth rates of tensile to the optimum curing age, these includes  non linear  conditions of tensile state,  non-elastic and its brittle behaviour at all times as it express  zero conditions in tension, this means that it has the ability to with stand pull force, it also reflect its weak ability to handle shear stress thus tends to cause deformation in material as it has poor elasticity. The reflection of its brittle influence the rate of tensile behaviour from concrete ductility, these are known to be a material on modern mechanics of concrete. These also considered as quasi brittle material, this behaviour were reflected as the system considered evaluating the growth rate of tensile strength that replaced cement and sand with these locally sourced addictives. the developed model monitor other reflected influential parameters such as variation of concrete porosity due it  compaction in placements, tensile behaviour reflects these effect that  subject  it to  mechanical properties of concrete, the study expressed the reaction of these parameters in the simulation, the evaluation of  these affected the details variation of tensile growth rate at different water cement ratios and curing age, the tensile behaviour that were monitored are  based on these factors in the study, these derived model were validated with Jaharatul et al 2018, and both parameters developed best fits correlation, the study is imperative because the system expressed the behaviour of tensile strength from concrete at different dimensions, experts can applied these concept to monitor tensile behaviour considering these parameters in its growth rates.

References:

[1] Ankit Nilesh Chandra Patel, Jayesh Kumar Pitroda, (2013). Stone Waste: Effective Replacement of Cement for Establishing Green Concrete, Inter. J. Innovative Tech. And Exploring Engineering, 2(5): 24-27. [2] Berry, E. E, Hemmings R. T., and Cornelius B. J. (1990). Mechanisms of Hydration Reactions in High Volume Fly Ash Pastes and Mortars. Concrete Composites, 12: 253-261. [3] Felekoglu, B. (2007). Utilization of High Volumes of Limestone Quarry Wastes in Concrete Industry (Self-Compacting Concrete Case). Resources, Conserv. Recycling, 51: 770-791. Freeda Christy, C., and Tensing D. (2010). Effect of Class-F Fly Ash as Partial Replacement with Cement and Fine Aggregates In Mortar. Indian Journal of Engineering and Materials. 17:140-144. [4] Hameed, and Sekar. (2009). Properties of Green Concrete Containing Quarry Rock Dust and Marble Sludge Powder as Fine Aggregate. [5] Hmaid Mir, A. (2015). Improved Concrete Properties Using Quarry Dust as Replacement for Natural Sand. International Journal of Engineering Research and Development, 11(3): 46-56. [6] Ho, D. W. S., Sheinn A. M. M., Ng, C. C. and Tam C. T. , (2002). The use of Quarry Dust for SCC. Applications. Cement and Concrete Research. 32(4): 505-511. [7] Hussin, M. W. (2002). Strength Properties of Self-Compacting Mortar Mixed with GGBFS. ICE-Construction Materials; 165(2):87-98. [8] Ilangovan, R., Mahendran, N. and Nagamani, K. (2008). Strength and Durability Properties of Concrete containing Quarry Rock Dust as Fine Aggregates. ARPN Journal of Engineering and Applied Science.3(5): 20-26. [9] Linoshka, S.P., and Hwang. (2016). Mix design and Pollution Control Potential of Pervious Concrete with Non-compliant Waste Fly ash, Journal of Environmental Management. 176:112-118. [10] Lohani, T. K., Padhil M., Dash K. P., and Jena S. (2012). Optimum Utilization of Quarry Dust as Partial Replacement of Sand in Concrete. Inter. Journal of Applied Sciences. 1(2): 391. [11] Malhotra, V. M. (2011) Fly Ash in Concrete. Canada. Dept. of Energy, Mines and Resourcesthe University of California. Digitized (pp. 178). [12] Manassa, J. (2010). Use of Crushed Granite Fine as Replacement to River Sand in Concrete. Leonardo Electronic Journal of Practices and Technologies. 17:85-96. [13] Mangiru, G. N., Karugu, C.K., Oyawa, W.O., Abuodha, S.O., and Mulu P.U. (2013). Partial Replacement of Natural River Sand with Crushed Rock Sand in Concrete Production. Global Engineers&Technologist Review. 3(4):7-14. [14] Mohammad Iqbal Malik, Syed Rumysa Jan, Junaid A. Peer, S., Azhar Nazir, Khubbab Fa Mohammad. (2015). Study of Concrete Involving Use of Quarry Dust as Partial Replacement of Fine Aggregates. 5(2): 2278-8719. [15] Peter, A. C. (2016). Chapter 21-Concrete mix Design. Civil Engineering Materials, 201-217. Poonam, Anoop Bishnoi, and Manju Bala. (2015). Effect of Quarry Dust as Partial Replacement of Sand in Concrete. International Journal of All Research Education and Scientific Methods 3(6):1-5. [16] Raharjo, D., Subakti, A., and Tabvio. (2013). Mixed Concrete Optimization using Fly Ash,Silica Fume and Iron Slag on the SCC’s Compressive Strength. Procedia Engineering, 54: 827-839. [17] Safiuddin, M., Raman, S. N., Zain, M. F. M. (2007). Flowing Concretes with Quarry Waste Fine Aggregate. J. Civil Eng. Res. Pract., 4(1): 17-25. [18] Safiuddin, M., Zain, M. F. M., and Yusof, K. M. (2000a). Utilization of quarry dust in developing high performance concrete. In D. [19] McTavish, G. Knights, F. M. Bartlett, R. K. Rowe, and S. Easa (Eds.), 2000 Annual Conference Abstracts - Canadian Society for Civil Engineering (pp.233). [20] Safiuddin, M, Zain, M. F. M, Yusof, K. M. (2000b). Development of High Performance Concrete Using Quarry Dust as a Partial Replacement of Sand. In: Proceedings of the PCI/FHWA/FIB International Symposium on High Performance Concrete, Orlando, Florida, USA. pp.173-182. [21] Sivakumar, A., and Prakash, M. (2011). Characteristic studies on the mechanical properties of quarry dust addition in conventional concrete. Journal of Civil Engineering and Construction Technology. 2(10): 218-235. [22] Sukesh, C., Krishna, K. B., Sai Teja, P. S. L., and Rao, J. K. (2013). Partial Replacement of Sand with Quarry in Concrete. Int. Journal of Innovative Technology and Exploring Engineering. 2(6): 254- 258. [23] Teychene, D. C., Franklin, R. E. and Erntroy, H. C. (1992). Design of Normal Concrete Mixes. Second edition,. Bre press, Watford, Herts, WD2 7QG, pp.1-46. [24] Venkata Sairam Kumar, N., Panduranga Rao, B., and Krishna Sai M. L. N. (2013). Experimental Study on Partial Replacement of Cement with Quarry Dust. International Journal of Civil Engineering and Technology (IJCIET), 2(3): 136-137. [25] Jaharatul D K L A, Nazri A, Roslli N M1 & Mohammed M.A (2018): the effect of quarry dust with cement by-products on properties of concrete Malaysian Journal of Civil Engineering 30(3):415-428 (2018).